E-FLITE Pulse XT 25e ARF, Инструкция по сборке

Страница: 8 / 36

8
Fuselage Servo Installation
Required Items
(2) Servos and hardware
(2) 23 5/8” rudder and elevator pushrods
(2) nylon clevises and silicone keepers
(2) pushrod keepers
Fuselage
Radio system (Tx, Rx, battery)
JR MatchMaker (optional)
Required Tools
1/16 in (1.5mm) drill bit #1 Philips screwdriver
Pin drill Low-tack tape
5/64 in (2mm) drill bit Tongue depressors/popsicle sticks
#0 Philips screwdriver Clothespins
Thin CA Felt-tip pen
Sidecutters
Ο Ο 1. Prepare the fuselage servos by installing the rubber grommets and
brass bushings in the mounting lugs. Place the servos in the fuselage and mark
the screw hole locations using a felt-tip pen.
Ο Ο 2. Using a 1/16 in (1.5mm) drill bit in a pin drill, drill the four mounting
holes for the rudder and elevator servos. Apply a small drop of thin CA to
each hole after drilling to strengthen the wood.
Ο Ο 3. Using a #0 Philips screwdriver, and the screws provided with the
servos, install the rudder and elevator servos in the fuselage mounting tray as
shown. In this view, the front of the fuselage is to the left.