E-FLITE Pulse XT 25e ARF, Инструкция по сборке

Страница: 7 / 36

Ο 2. Slide the vertical stabilizer into place. It will be necessary to deflect the
rudder to the right in order for the rudder horn to clear the elevator. The 4-40
rods will pass through the horizontal stabilizer and the fuselage. The forward
end of the vertical stabilizer assembly will slide over the turtledeck tab, and the
fin post will slide between the aft fuselage sides.
Ο 3. Install the two washers and retaining nuts with a 1/4” nut driver or
wrench. Tighten them enough that the tail assembly is seated fully and is not
loose.
Tail Installation
Required Parts
Fuselage
Vertical stabilizer
Horizontal stabilizer
(2) 4-40 x 1/4" locknuts
(2) #4 steel washers
Required Tools
1/4” nut driver or wrench
Ο 1. Place the horizontal stabilizer on the aft fuselage. Its leading edge needs
to locate under the tab on the rear turtledeck former as shown.
7