Afterburner Ring Application
To add the optional Afterburner Ring.
1. Remove the 2 screws (
A
) securing the vertical fin (
B
) and remove the fin.
2. Remove the 2 screws (
C
) holding the tailcone (
D
) and remove the cone.
3. Connect the afterburner connector to the preinstalled servo lead found under
the vertical fin.
4. Apply contact cement (
E
) to the mating surface of the fuselage where the
afterburner ring (
F
) will fit.
5. Fit the ring to the fuselage.
6. Reinstall the tailcone and the vertical fin.
7. Unplug the ESC connector from the receiver and plug the ESC into a
Y-connector (not included). Plug the Afterburner Ring lead into the other
Y-connector and plug into the throttle channel of the receiver.
EN
F-16 Falcon 80mm EDF
10
C
D
F
E
A
B
