21
E-flite Enticememt F3P Profile Assembly Manual
8. With the ailerons and aileron servo centered,
check the distance between the horns and pushrods.
There should be a 1/16-inch (1mm) gap between them.
If not, use side cutters to trim the pushrods to the correct
length.
9. Slide the heat shrink tubing on the control horns,
then slide the pushrods into the heat shrink, centering
the heat shrink between the two. Use a soldering iron to
shrink the tubing onto the control horns and pushrods for
both ailerons.
Note
: You must use a soldering iron to shrink the tubing.
The heat from other methods cannot be controlled as well
and will cause damage to your airframe.
10. Repeat Steps 7 though 9 for the opposite aileron
pushrod installation.
