8
E-flite Enticement F3P Profile Assembly Manual
Airframe Assembly
Required Parts
Vertical fuselage
Foam firewall
Top fuselage stiffener (2)
Bottom fuselage stiffener (2)
Stabilizer/rear horizontal fuselage
Main wing/front horizontal fuselage
Required Tools and Adhesives
Foam-safe CA
Square
Foam-safe CA activator
Straight edge
Low tack tape
Note
: Although it is easy to build your Enticement, it
is also easy to build it crooked. Take your time with
each step and check the alignment of the model as you
progress. A straight model will perform much better than
one that is not.
1. Place a piece of waxed paper or the packaging from
your model onto your work surface. With the main wing
resting on the waxed paper, slide the rear horizontal
fuselage in position. Use a straight edge to check the
alignment of the two pieces, aligning the holes in the
center of each. (Make sure the top of both fuse pieces
are facing up.) Use foam-safe CA to glue the two pieces
together. Allow the CA to fully cure before proceeding.