30
E-flite Enticement F3P Profile Assembly Manual
5. Position a 2-inch (50mm) carbon rod between the
bottom of the aileron and each of the drag brakes. Use
foam-safe CA to glue the carbon rods to the aileron.
Double-check the alignment to make sure the drag brakes
are square to the aileron, then use foam-safe CA to glue
the carbon rods to the drag brakes.
6. At this time it is suggested to go back and check all
the glue joints to make sure they are solid. Apply foam-
safe CA to any areas that may need a little extra glue.
7. Use foam-safe CA to glue the foam wheel pant onto
the molded skid. Use the notch in the wheel pant to
center it on the skid.
