17
E-flite Enticememt F3P Profile Assembly Manual
4. Plug the servos into the radio system and make sure
they operate and are centered as well. Also center the
trims on the transmitter at this time. If you are using a
computer radio, start with a clear model program and
check that all sub trims are set to 0 and all throws are set
to 100%. Prepare the servos for installation by attaching
the long 3D arms on the servos and by removing any
unnecessary arms from the elevator and rudder servo
horns as shown.
WARNING
: The next step will void your servo warranty!
Hint
: If you really want to lighten up the Enticement there
are a few things that can be done.
These next steps will net almost 3 grams in savings.
You will need extra 1mm carbon rod and extra heat shrink
tubing to complete the following steps.
A.
Take the case off of the bottom of the S60 servo.
You can also eliminate the servo control horn by using
a piece 1mm carbon rod cut to the correct length. This
must be done with great caution.
C.
Center the servo using the radio system as described
in Step 4.
