8
E-flite Diamante 5e ARF Assembly Manual
Safety, Precautions, and Warnings
As the user of this product, you are solely responsible for
operating it in a manner that does not endanger yourself
and others or result in damage to the product or the property
of others.
Carefully follow the directions and warnings for this and any
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
This model is controlled by a radio signal that is subject to
interference from many sources outside your control. This
interference can cause momentary loss of control so it is
necessary to always keep a safe distance in all directions
around your model, as this margin will help to avoid collisions
or injury.
• Always operate your model in an open area away from cars,
traffic, or people.
• Avoid operating your model in the street where injury or
damage can occur.
• Never operate the model out into the street or populated
areas for any reason.
• Never operate your model with low transmitter batteries.
• Carefully follow the directions and warnings for this and any
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
• Keep all chemicals, small parts and anything electrical out of
the reach of children.
• Moisture causes damage to electronics. Avoid water exposure
to all equipment not specifically designed and protected for
this purpose.
Aileron Installation
Required Parts
• Wing
• Receiver
• Servo w/hardware (2)
• Long servo arm (2)
• CA hinge (8)
• 3
3
/
8
in (86mm) pushrod wire (2)
• Clevis (2)
• Clevis retainer (2)
• Nylon control horn (2)
• 3mm x 30mm machine screw (2)
• Control horn standoff (2)
• Control horn washer (2)
• Puhrod wire connector (2)
• Servo extension, 6 in (152mm) (2)
Required Tools and Adhesives
• Rotary tool
• Drill bit: 1/16 in (1.5mm)
• T-pins
• Thin CA
• String
• Weight
• Felt-tipped pen
• Pen drill
• Threadlock
• Tape
• #1 Phillips screwdriver
1. Locate four CA hinges. Place a T-pin in the center of
each hinge.
