The standard sketch map when the kit install completion.
Assemble the lower wing to the fuselage.
Insert the lower wing joiner to the lower wing.
1
Lower wing joiner (25x925mm)
2
Washer (6x12mm)
2
Screw (6x35mm)
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A
A ’
A = A '
B = B '
B
B ’
Lower wing joiner (25x925mm)
TP Screw(2.3X12mm)
Apply instant type AB glue to the control horn and the slots in the aileron,
insert the control horn to the slots as illustration.
Lock the linkage to the control horn with screws and nuts
as below.
Nut 3mm
Screw (3x16mm)
Accessory list for the coming installation steps.
1
Main wing joiner (25x925mm)
6
8
9
4
7
10
Wheel (140mm)
2
LockNut (4mm)
Accessory list for the coming installation steps.
Assemble the wheels to the undercarriage.
Wheel (140mm)
2
Washer (6x12mm)
2
Washer (3x6mm)
2
Screw (6x15mm)
2
Screw (3x10mm)
Double-sided adhesive
2
Nose landing gear
2
PVC
Lock Nut (4mm)
1
6
Screw (3x16mm) 2
Assemble the cover plate to the fuselage with screws.
Epoxy the wheel pants to the undercarriage as illustration.
2mm
Trim the PVC parts along the shaded line.
Stick the double sided adhesive around the edge of the
PVC part
1
Double-sided adhesive
81
17
77
79
80
78