Fix the steel wires in the stabilizer.
Accessory list for the coming installation steps.
Screw (3x10mm)
4
Collar (3mm)
Collar (5mm)
2
2
1
1
Tail landing gear
Tail wheel (45mm)
1
aluminium plate
2
Clevis
2
Copper joiner
2
2
Aluminum tube
2
Steel wire (0.5x1700mm)
TP Screw (3x16mm)
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x6mm)
4
Washer(3x6mm)
Pivot & round hinges(4.5x67mm)
1
The connection working sketch map of the lines for the
rudder and tail landing gear.
According to the illustration below bend the tail landing
gear wire and cut off the surplus part.
Install the tail landing gear.
20mm
Collar (5mm)
aluminium plate
115mm
25mm
Collar (3mm)
Collar (3mm)
2
Steel wire (0.5x1700mm)
Screw (3x16mm)
3
vScrew (3x16mm)
3
Washer(3x6mm)
Fix the tail landing gear to the fuselage.
Washer(3x6mm)
39
40
38
41
10
42
Trim a slot and drill a hole in the rudder for helping
assemble the tail landing to it.
25mm
25mm
3mm
Apply instant type AB glue to appropriate position of the rudder and
the pivot & round hinges. Insert the pivot & round hinges to the rudder.
Make sure hinges are
mounted in the same line.
2
pivot & round hinges(4.5x67mm)
1mm
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between the rudder
and tail edge.
Rudder
Assemble the rudder to the stabilizer fin.
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Clevis
Washer(2x5mm)
Install the servo of the rudder.
Assemble the servo of the rudder in the fuselage and
connect the servo and the rudder via steel wires.
45
48
46
47
11
43
44