2
2
Rod (2x300mm)
Pivot&round hinge(4.5X67mm)
6
Collar (2mm)
4
2
5
Nut (2mm )
Nut (4mm )
1
Stabilizer joiner (12x485mm)
1
Stabilizer joiner (12x330mm)
12
Washer(4x8mm)
6
Washer(3x6mm)
Screw (2x16mm)
8
2
Clevis
6
Control horn
2
Screw (3x16mm)
4
Steel wire (0.5x350mm)
Screw(4x25mm)
1
Screw(4x35mm)
2
Screw(3x10mm)
1
Accessory list for the coming installation steps.
Apply instant type AB glue to appropriate position of the elevator and
pivot & round hinges. Insert the pivot & round hinges to the elevator.
1mm
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Keep about 1mm width space between the elevators
and the stabilizers.
Elevator
6
pivot & round hinges(2.5x48mm)
Make sure hinges are
mounted in the same line.
Assemble the elevators to the stabilizers via pivot & round hinges.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Assemble the servos to appropriate position in the stabilizers.
Apply instant type AB glue to the wood horn and the slots in the
elevatorinsert the control horn to the slots as illustration.
16
Aluminum tube
27
28
29
8
30
31
Install the engine mount tubes to the fuselage,lock them
from inside of the fuselage.
Assemble the engine to the fuselage via the engine
mount tubes and screws.
Screw (5x20mm)
Washer(5x10mm)
Drill four holes at the diameters as shown for engine
mount.
Install the plastic tubes to the slot of the ply as illustration.
Epoxy the plies to the fuselage steadily.
1
Ply
8
Plastic tube (4x18mm)
Insert the muffler to the holes in the fuselage as illustration.
6.2mm
Washer(5x10mm)
Screw (5x35mm)
4
Washer(5x10mm)
4
Screw (5x35mm)
4
Washer(5x10mm)
4
Screw (5x20mm)
55
54
58
56
57
13
55
