Install the nylon control horn and connect the linkage.
Nut 2mm
Screw (2x16mm)
Lock the linkage to the control horn with screws and nuts
as below.
1
Stabilizer
joiner (12x485mm)
1
Stabilizer
joiner (12x330mm)
Assemble the stabilizers to the tail fuselage through the
tail tube.
4
Washer(3x6mm)
Screw (3x16mm)
4
Fix the stabilizers to the tail fuselage via screws.
Screw
Spring Washer
Steel wire
Steel wire
The sketch map of the steel wires work for stabilizer.
Fix the steel wires in the stabilizer.
Steel wire
Aluminum tube
Screw (4x25mm)
Nut 4mm
Washer (4x8mm)
Screw (4x35mm)
32
9
34
33
37
36
35
Accessory list for the coming installation steps.
Steel wires
Steel wires
Side view
Top view
The sketch map of the steel wires for the rudder in the
fuselage.
Screw (3x16mm)
Assemble the tail landing gear cover to the fuselage.
Tail wheel (45mm)
Collar(3mm)
Collar(3mm)
Tail landing gear
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The sketch map should be when the rudder and stabilizer
install completion.
A
A = A ’
B = B ’
A ’
B
B ’
Washer(3x6mm)
1
Linkage Stopper
8
4
Washer(5x10mm)
Screw (5x35mm)
4
Screw (5x20mm)
2
4
Plastic tube (2x400mm)
Fuel tank (550cc)
1
Cable tie
2
1
Rod (2x250mm)
Blind Nut (5mm)
8
Plastic tube (4x18mm)
4
TP Screw (2.3x10mm)
1
Servo mount
4
Oil tank mount
195mm
The front view once the engine with muffler install completion.
The side view once the engine with muffler install completion.
53
52
12
50
49
51