Dyson DC15, Руководство по обслуживанию

Страница: 46 / 51

service manual
Issued 05/05
43
Fitting notes
Position the recess on the exhaust seal
onto the locator on the duct. Press the filter
duct and exhaust seal firmly onto the duct.
Refit the inlet seal onto the side of the duct.
Lower the upright switch onto the retaining
pegs on the inside of the duct. When fitted
correctly, the switch lever should point towards
the rear of the duct. Pull the upright switch
loom through the other side of the duct until the
grommet is adequately sealed. Fit the upright
switch actuator onto the third retaining peg.
When fitted correctly the actuator should point
towards the front of the duct. Refit the upright
switch cover and long screw.
Locate the ends of the upright switch loom
into the hole on the inside of the duct. Connect
the upright switch loom to the two outer
terminals of the upright switch.
Locate the thick part of the wall on the
filter duct into the wide channel inside the
exhaust seal. Fit the exhaust seal around the
edges of the filter duct ensuring the filter duct
sits centrally within the seal.
208
209
205
206
207
Push the tool clip into the side of the duct.
204