Dyson AM04, Руководство по эксплуатации

Страница: 2 / 23

2 3
Controls
Heating mode Cool air mode Power and remote control* Tilt function
Remote control docks magnetically
Attach remote control to top of heater
with the buttons facing down.
To operate, point remote control toward the front of the base.
Carefully hold the base and the top of the air loop amplifier.
Tilt forward or backward for the required airflow angle.
On first use, the heater will default to a temperature
1°C higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set. To change the airflow speed press the airflow speed
control button. The digital display will show the
new speed; after 3 seconds it will change back to
the target temperature. To start the heater oscillating, press the oscillation
control button. To stop the heater oscillating, press it
again. The heater will not oscillate when the control
buttons are pressed.
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from
red to blue. To adjust the airflow speed use the airflow
speed control.
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red.
For best results turn on the oscillation control.
Select a high flow of air.
Select a low flow of air.
To return to heating mode
Whole room
Spot heat
Stand by
on/off
*Remote control with select models only.
Airflow speed
control
Oscillation
on/off
Thermostat
control
1. Power on 2. Thermostat control
Select the desired room temperature. Pressing red
increases the target temperature, blue decreases
it. The heater will not operate unless the target
temperature is above the room temperature.
3. Airflow speed control 4. Oscillation control