C H A P T E R 1
Main Dyno Power
Torque Cell Installation Guide for Model 250i/250iP DynoWare RT Dynammometers
1-4
C
ONNECTING
AND
D
ISCONNECTING
THE
P
OWER
—I
N
G
ROUND
D
YNO
Use the following steps to connect and disconnect power to the in ground dyno.
Always turn the power off when connecting and disconnecting cables.
1
Use the main breaker to turn power on and off to the dyno.
The main breaker is located inside the CPI door. When the handle is in the down
position all power into the dyno is turned off.
2
Disconnect the power plug to ensure all power has been removed from the dyno
before installing the DynoWare RT electronics.
Components attached to and within the dynamometer operate with
potentially lethal voltages. The power cord must be disconnected from the
power source before servicing electrical components or wiring
.
Figure 1-2: Main Dyno Power—In Ground Dyno
PD231
main breaker
power plug
