C H A P T E R 1
Accessing the Dyno
Torque Cell Installation Guide for Model 250i/250iP DynoWare RT Dynammometers
1-6
4
Remove the two 5/16-inch bolts and washers securing each of the carriage clamps
and shims and set aside.
5
Remove the three carriage clamps and shims and set aside.
6
Remove the two 5/16-inch bolts and washers securing the nut block and shim and
set aside.
7
Remove the nut block and shim and set aside.
8
Remove the six 1/4-20 x 5/8-inch pan head screws securing the center panel to
the dyno carriage and set aside.
9
Remove the center panel and set aside.
Figure 1-4: Remove the Center Panel
TC081
screw
center panel
carriage clamp
washer
bolt
shim
nut block
shim
