1-9
T O R Q U E C E L L I N S T A L L A T I O N
Load Cell Installation
Version 2
Torque Cell Installation Guide for Model 250i/250iP DynoWare RT Dynammometers
LOAD CELL INSTALLATION
This section describes how to remove the existing bar on the eddy current brake and
install the load cell. Use the following instructions for both the above ground and in
ground dynos.
You will need the following part:
1
Verify the main dyno power is disconnected. Refer to“Main Dyno Power” on page
1-3 for more information.
2
Remove the two bolts and nuts securing the existing bar on the eddy current brake
and remove the bar. Set the bolts and nuts aside.
Figure 1-7: Remove the Existing Bar
part
description
load cell and cable, above ground
P/N 76950573
load cell and cable, in ground
P/N 76950759
bar
