Dynapac PL 1000 RS, Руководство по эксплуатации и техническому обслуживанию

Страница: 201 / 230

F 47
F_PL10
00RS_G
B
.f
m
47-
7
6
-
0
4
.0
7
3.6 Water system
Water tank
Check the water tank level before start-
ing work by inspecting the filler gauge (1)
on the right-hand side of the water tank.
If necessary, top up the tank.
- Unscrew filler aperture (2), fill with wa-
ter to top edge then close aperture
properly.
$
If necessary, and at least every 500 op-
erating hours, the inside of the tank
needs to be cleaned. Clean the water
tank as thoroughly as possible once it is
empty.
Spray out the tank as thoroughly as pos-
sible with a water jet lance which can be
inserted into the tank through the filler
aperture.
If the machine is not operating continuously, this water should be changed once a
year.
- Completely drain the tank by opening
up the drain valve (3) behind the right-
hand flap on the engine compartment,
leaving the valve in its Open position.
- The dissolved sediment runs through
the open drain valve.
- After completion of cleaning work,
close the drain valve and the sealing
cover on the water tank.
This water is definitely not drinking qual-
ity!
$
If there is a risk of sub-zero tempera-
tures, completely drain the water tank
using the drain valve, leave the valve
open, unfasten the connecting lines and allow them to drain. Remove sealing cap
from water filler apertures.
WTank_Pl600.tif
2
1
Wasser1_PL1000.wmf
3