Dynapac PL 1000 RS, Руководство по эксплуатации и техническому обслуживанию

Страница: 131 / 230

D 93
D_PL100
0RS_G
B
.f
m
9
3
-1
12
-
04
.0
7
Ending the milling procedure
Stop the machine and raise at the end of the milling lane:
- The drive lever (70) is located in centre position.
- If the automatic levelling device is used for planing, first shut down the levelling unit
using switches (37) and (38).
- Move selector switch for the front board (35) and the moldboard (34) (
&
) to „0“.
- Raise machine uniformly by pressing both switches (73) + (74) together until the
desired ground clearance has been reached. Where applicable, press the switch
for raising and lowering speed (36) to rapid adjustment beforehand.
- Allow milling drum drive (31), water pump (33) and upper conveyor (32) to run on
briefly, then switch to „0“.
- Move switch (38) to transportation speed (hare).
- Set preselector controller for driving speed (27) to around 50%.
- Start to move the machine by deflecting the drive lever out of its centre position and
move out of the construction site area. If necessary, use the preselector controller
(27) to slowly increase the driving speed.
- Where necessary, guide the upper conveyor using the control lever (71).
$
Comply with safety regulations when moving the machine outside the construction
site!
28
27
36 32 35 31 34 33
Panel2_500_1000.wmf/Panel4_1000.bmp
71
70
73
74
38 37