Dynapac D.ONE, Руководство по эксплуатации

Страница: 175 / 190

Code Fault reaction Description of fault Possible cause Ter-
minal
on
BLM
Input
code
for
diag-
nose
5015 Only warning,
horn sounds,
display module is
dark,
Potential 15 missing
Control has switched relay
K11, no voltage
Fuse F 103 defective
Relay K11 defective
Cable breakage in wiring loom
X3:20 notpos-
sible
5016 Output is
switched off,
functionno longer
possible
Battery voltage too low
Battery voltage already
below 11 Volt when
switching on
Battery acid level too low
Battery defective
Battery discharged
0561
5020 Only warning,
horn sounds
Input engine oil pressure,
B 06
Oil pressure switch delivers
the signal "no engine oil
pressure"
The oil pressure switch has
measured a too low oil pres-
sure. The engine may be shut
down.Should this message be
displayed even though the
engine is not running, the fol-
lowing faults should be exam-
ined:
Current path has short circuit
to ground
Engine oil level not correct
Engine oil pump defective
Pressure relief valve after
engine oil filter soiled
Oil pressure switch defective
X3:03 5020
5021 Engine shut
down by too low
oil pressure
Input engine oil pressure,
B 06
Fault 5 0 2 0 present longer
than 8 seconds
Engine is shut down
see fault code 5 0 2 0 X3:03 5020
5025 Engine running No rotary speed signal
from the generator regu-
lator
Only warning
Generator regulator defective
Line between regulator and
control interrupted
X3:41 -
5031 Machine standing Engine stops, engine
stalled
Lack of fuel
Engine stopped even though
the BLM control did not submit
a corresponding command
General fault codes diesel engine,
machine
Appendix – List of fault codes
D.ONE 175