Dynapac CC7200, Инструкция по эксплуатации

Страница: 89 / 101

Maintenance measures - 250 h
4812158801_E.pdf 2018-04-03
Maintenance measures - 250 h
Every 250/750/1250/1750..... hours of operation (every
3 months)
Park the roller on a level surface.
The engine must be switched off and the
parking brake activated when checking or
adjusting the roller, unless otherwise specified. Park the roller on a level surface.
The engine must be switched off and the
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning. Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Pump drive - Oil level, Check - Filling
Fig. Pump gear
1. Dipstick
1
Position the roller on a level surface.
When checking the oil level, switch the engine off
and ensure that the parking brake is applied. When checking the oil level, switch the engine off
and ensure that the parking brake is applied.
Open the right door of the engine compartment and
unscrew the dipstick (1).
The oil level should be between the two marks on the
lower edge of the dipstick.
Fill with transmission oil if required, see Lubricant
Specification.
Ensure that the rubber gasket between the dipstick
and the gear housing is in place, and screw in the
dipstick.
81