Dynapac CC7200, Инструкция по эксплуатации

Страница: 39 / 101

Machine description
4812158801_E.pdf 2018-04-03
Display/Regeneration of Diesel Particle Filter
(DPF filter)
2
1
Fig. Instrument panel
1. Engine diagnostics
2. Regeneration
3. Regeneration selector (DPF selector)
3
The lamp (DPF lamp) in the regeneration switch (3)
comes on to indicate that the filter has reached a level
such that regeneration of the filter will soon be
required.
The lamp in the switch (3) starts to flash when the filter
starts to become full.
Regeneration of the filter should then take place as
soon as possible, as some reduction in engine power
can be noted. If the switch (3) is in auto mode,
regeneration starts automatically when required by the
system.
The regeneration of the DPF filter lasts for approx. 30
minutes, and the machine can be operated as normal
during this time.
The auto mode is the normal mode. The delayed
mode should only be used if you are in an
unsuitable location, e.g. in a tunnel, under a roof,
etc. The auto mode is the normal mode. The delayed
mode should only be used if you are in an
unsuitable location, e.g. in a tunnel, under a roof,
etc.
The free space above the roller must not be less
than the height of the cab. Temperatures in the
region of 350°C (662°F) can be generated at the
exhaust pipe when performing regeneration of the
DPF filter. The free space above the roller must not be less
than the height of the cab. Temperatures in the
region of 350°C (662°F) can be generated at the
exhaust pipe when performing regeneration of the
DPF filter.
2 1
If it is not appropriate to allow the machine to perform
automatic regeneration, perhaps because the machine
is in an unsuitable location or the prevailing working
conditions do not permit this, it is possible to delay
regeneration by activating delayed regeneration.
The regeneration switch (2) is then turned to the left,
to the position for delayed filter regeneration, and the
delayed regeneration lamp (1) comes on.
31