Command with FXS Gateway
There are 12 digits on label on the back panel of the device, or command as
usr/config$ ifaddr –ifshow (find the list information of Ethernet address, it is
MAC Address.
usr/config$ setmac (set as 2 digits as a group)
00
01
a8
00
xx
xx
if confirm, press y
Steps 4.2:
Set IP Address
usr/config$ ifaddr –ip xxx.xxx.xxx.xxx –mask xxx.xxx.xxx.xxx –gate
xxx.xxx.xxx.xxx
(Please refer to Chapter 19.7.6)
Steps 4.3:
Hardware version confirmation
Upgrade 2MB Rom may change the hardware column. If it is not as the same as the
one, which is found on the label of back panel, please command as
usr/config$ rom –hwver x.x
Steps 4.4:
[commit], [reboot]
19.6 Commands with FXS Gateway
The following table lists all of the commands that you can use with the FXS Gateway. Refer to
the following chapters for descriptions of commonly used commands.
This user’s guide describes commands that are helpful for configuring the FXS
Gateway.
Using commands not documented in the user’s guide can damage the unit and
possibly render it unusable.
Table 19-1 Commands with FXS Gateway
Command DESCRIPTION
help help/man/?[command]
quit quit/exit/close.
debug
show debug message.
reboot
reboot local machine.
flash
clean configuration from flash rom.
commit
commit flash rom data.
ifaddr
internet address manipulation.
Command List
19-13
