11
D
Copyright © 2014 - 2022 by Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
Mounting of the projector
For further help on assembly please watch our assembly videos: http://www.dynamicprojection.com/mirror-head-assembly/
1
2
3
5
6
4
7.
Mount the base-plate to the projector.
WARNING: Secure the projector at any time so it cannot fall out or down. Use a second person to help.
8.
Lock-in the Mirror Head into the base-plate and secure the two screws at the front and the two screws at the bottom.
NOTE: This step of the installation can be reversed.
9.
Connect the RS232 and AC power-cord to the projector and control unit.
MH19
MH23
7.
7.
8.
8.
1
2
3
5
6
4
Flat side
1.
Prepare the setscrew on the hex key.
2.
Turn the setscrew into the drive arm
by two turns.
3.
Slip over the end-stop (brass part)
over the pan drive shaft.
4.
Take the whole drive arm end slip it
over the pan drive shaft until it
reaches the end-stop.
5.
Secure the setscrew with the hex key.
Make sure that the screw is tightened
on the flat side of the D-cut shaft.
6.
Connect the motor signal cable and
mount the glue strip on the motor.
Version 2.7
