4
Copyright © 2014 - 2022 by Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
Safety
This device has left our company in absolutely perfect condition.
In order to maintain this condition and to ensure a safe operation,
it is absolutely necessary for the user to follow the safety
instructions and warning notes written in this user manual.
NOTE: Damages caused by the disregard of this user manual
are not subject to warranty. The dealer will not accept
liability for any resulting defects or problems.
Never look directly into the light source of an attached
projector!
Keep away from children!
There are no user serviceable parts (fuse) inside this unit.
If the device has been exposed to drastic temperature fluctuation,
do not switch it on immediately. The arising condensation water
might damage your device. Leave the device switched off until it
has reached room temperature.
Please make sure that there are no obvious transport damages.
Should you notice any damages on the A/C connection cable or
on the control unit, do not take the device into operation and
immediately consult your dealer.
This device falls under protection-class I. The power plug must
only be plugged into a protection class I outlet. The voltage and
frequency must exactly be the same as stated on the device.
Wrong voltages or power outlets can lead to the destruction of
the device and to mortal electrical shock.
Always plug in the power plug last. The power plug must always
be inserted without force. Make sure that the plug is tightly
connected with the outlet.
Never let the power-cord come into contact with other cables!
Handle the power-cord and all connections with the mains with
particular caution! Never touch them with wet hands, as this
could lead to mortal electrical shock.
Never modify, bend, strain mechanically, put pressure on, pull or
heat up the power cord. Never operate next to sources of heat
or cold. Disregard can lead to power cord damages, fire or mortal
electrical shock.
The cable insert or the female part in the device must never be
strained. There must always be sufficient cable to the device.
Otherwise, the cable may be damaged which may lead to mortal
damage.
Make sure that the power-cord is never crimped or damaged by
sharp edges. Check the device and the power-cord from time to
time.
If extension cords are used, make sure that the core diameter is
sufficient for the required power consumption of the device. All
warnings concerning the power cords are also valid for possible
extension cords.
Always disconnect from the mains, when the device is not in use
or before cleaning it. Only handle the power-cord by the plug.
Never pull out the plug by tugging the power-cord. Otherwise,
the cable or plug can be damaged leading to mortal electrical
shock. If the power plug or the power switch is not accessible,
the device must be disconnected via the mains.
If the power plug or the device is dusty, the device must be
taken out of operation, disconnected and then be cleaned with
a dry cloth. Dust can reduce the insulation which may lead to
mortal electrical shock. More severe dirt in and at the device
should only be removed by a specialist.
There must never enter any liquid into power outlets, extension
cords or any holes in the housing of the device. If you suppose
that also a minimal amount of liquid may have entered the
device, it must immediately be disconnected. This is also valid,
if the device was exposed to high humidity. Also if the device is
still running, the device must be checked by a specialist if the
liquid has reduced any insulation. Reduced insulation can cause
mortal electrical shock.
There must never be any objects entering into the device.
This is especially valid for metal parts. If any metal parts like
staples or coarse metal chips enter into the device, the device
must be taken out of operation and disconnected immediately.
Malfunction or short-circuits caused by metal parts may cause
mortal injuries.
Version 2.7
