14
DG
Copyright © 2014 - 2022 by Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
Mounting of the Mirror Head
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
When rigging, de-rigging or servicing the device staying in the area below the installation place, on bridges, under high working places
and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before taking into
operation for the first time and after changes before taking into operation another time.
The device should be installed outside areas where persons may walk by or be seated. The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used. The device must never be
fixed swinging freely in the room.
Devices in hanging installations may cause severe injuries when crashing down! If you have doubts concerning the safety of a possible
installation, do NOT install the device! Mount the device to your trussing system using an appropriate clamp. For overhead use, always
install an appropriate safety bond.
WARNING: OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to) calculating working
load limits, installation material being used, and periodic safety inspection of all installation material and the device. If you
lack these qualifications, do not attempt the installation yourself, but instead use a professional structural rigger. Improper
installation can result in bodily injury and or damage to property.
~90°
Default Mode
Examples of positioning the Mirror Head.
The illustrations show the approximate usable angular range of the projection
cone depending on the operation modes. The shown ranges may differ depending
on the lens-shift and blocking parts of the projector or mounting constructions.
The modes can be set in the firmware of the Mirror Head using the „Mirror
angel“ menu.
Default Mode
(„90 Degrees“), this is the „90° Tilt“ mode available on all Mirror
Head models.
Version 2.7
~180°
Default Mode