BlueWave® MX-Series 1 Channel Curing Systems User Guide
25
NOTE: The following lightguide instructions apply to the MX-150 emitter operation only.
The MX-250 emitter emits a flood pattern, so lightguide references are not applicable to
this unit.
The insertion of the 5-mm lightguide adapter, or an actual lightguide, into the end of the
LED emitter needs to be fully seated. The device utilizes 3 spring plungers inside to hold
the lightguide in place. Excessive vibration may cause the lightguide to shift position and
cause an error condition. End users must provide means through the use of a fixture or
other device to address this situation.
Upon startup of the unit, an intro screen will appear. After 4 seconds, the control screen
should appear in the display. It will be in administrator mode the first time the unit is
started.
Control Screen
The control screen is used to set up and run curing cycles. This screen allows users to
switch back and forth between administrator and production modes as well as between
timer and manual operating modes. It is also where the cycle’s time and power settings
are set.
Figure 11. Control Screen Components
Information Button
—
Loads the system information screen.
Refer to “
” on page
31 for more information.
Irradiating Time
Operation Mode
Information
Button
Settings Button
Power Button
Run/Stop Cycle
Button
Emitter Type
Program Button
Alarms Icon
Admin/Production
Modes Toggle
