42
/
66
SM-1 Ev6/25062014
6.21 Adjustment of the stabilizer length
-
Tighten the left side to the minimum length (Picture 91)
-
Loosen the right side so that the arm can move (Picture 92)
-
Adjust the axes of the pulley, pillar and hydro motor in one line use the geometry adjustment tool no.1
(Picture 93) or laser tool (Picture 95, 96)
-
Use the geometry adjustment tool no.2 for distance adjustment between the rest of arms (Picture 94)
-
Tighten the right side of the stabilizer
-
Check the clearance between the wheels and case
-
Following adjustment of the stabilizer length, it is necessary to check the chain tension and wheel geometry
and make possible adjustment (see
6.22 Adjustment of the wheel geometry
)
ATTENTION: see section Service Bulletin
8.2 Stabilizer – pressed in – 1S01K271
8.10 Stabilizer – pressed in
Picture 91
Picture 92
Picture 93
Picture 94
Picture 95
Picture 96
