35
/
66
SM-1 Ev6/25062014
6.15 Exchange of the angle gear UNI M8
Dismount:
-
First, mark the original position of the wheel suspenders, console, and distance rings
-
Lift the mower (the wheels must be at least 150 mm over the ground)
-
Turn the suspenders in the straight direction
-
Dismount the console - see
6.16 Exchange of the driving belts SPA1650L
-
Pull the pulley out
-
Support the wheels to secure them against slipping out
-
Dismount the wheel housing - see
6.20 Exchange of the wheel housing
-
Dismount the cover of angle gear on the bottom part of the arm (ATTENTION – this sheet secures the
wheel suspension from slipping out) (Picture 76)
-
Pull out the angle gear
Mounting:
Don´t forget to put on the Stop ring on the new angle gear (Picture 75)
- Screws of the angle gear cover have to be glued (LOCTITE 243)
-
The wheels place in the teeth in straight direction (or adjust the steering geometry after mounting)
-
MIND a position of the needle bearing securing ring in the arm groove
-
Lubricate the needle bearings, pulley shaft and the steering teeth transmission (grease) (Picture 75)
-
ATTENTION!!! Mount by hands only – clean the shaft, lubricate it and push in smoothly by hands!!!
-
Tighten 4 screws, use thread glue LOCTITE 243
-
Put on spacing ring 17-22 v41, key, belt pulley, spacing ring 17-22-v5,5
-
Mount the belt on the hydraulic motor pulley and console pulley
-
Push the console on the shaft by hands
-
Tighten the screws, follow the order 3, 2 a 1 (Picture 74)
-
Secure the screw 2 with glue (LOCTITE 243)
-
Check the clearance between transmission and the arm, approximately 4mm (Picture 73)
-
Mount the wheel housing - see
6.20 Exchange of the wheel housing
-
In case the oil of the gear is empty, refill it with cca 100cm
3
MOBILUX EP004
-
Tighten the by-pass valve of the pump
Picture 73 Picture 74
Picture 75 Picture 76
4 screws
Stop
ring
Clearance
approximately 4 mm
filling grease MOBILUX
EP004 100cm3 (100ml) for each
