6
❏
1. Remove the (2) 3x8mm pan head self-tapping screws (L) from
the receiver battery box (65). Remove the receiver battery box lid
(66). Note: (4) Four “AA” batteries should already be installed
from a previous step, but if not then install the batteries into
the receiver battery box. Install the receiver battery box into the
receiver battery holder. Tuck the wires into the groove in the radio
box so that they do not get crimped under the radio box lid.
Re-install the receiver battery box lid and secure it in place with the
(2) 3x8mm pan head self-tapping screws.
❏
2. Route the receiver battery box wire through the shock tower
and across the top of the transmission. Tuck the receiver battery
box wire into the wire holder molded into the top of the
transmission case. Route the wire under the bottom of the engine
and along the side of the fuel tank. Note: Make sure the receiver
battery box wire is routed so that it cannot get caught in any
moving parts, like the engine’s flywheel. Secure the receiver
battery box wire to the fuel tank using a small tie-straps and the
molded tabs on the side of the fuel tank. See photo in step 5 on
page 7.
❏
1. Remove the receiver box cover (69) from the radio plate (68)
by removing the (2) 3x8mm pan head self tapping screws (I).
❏
2. Remove the radio plate/receiver box (68) from the chassis (1)
by removing (4) 3x10mm flat head machine screws (B) from the
bottom of the chassis.
❏
3. Place the throttle servo into the radio plate as shown. Route
the servo wire through the hole in the receiver box. Note the
location of the servo output shaft. Secure the servo to the radio
plate using four 3x8mm screws (L).
RADIO PLATE INSTALLATION
RECEIVER BATTERY INSTALLATION
