18
1. Secure the radio plate (68) to the chassis (1) using (4)
3x8mm flat head screws (A).
2. Secure the radio box cover (69) to the radio plate (68)
using (2) 3x10mm self tapping screws (L).
3. Attach the fuel tank (56) to the chassis (1) using (4)
3x8mm flat head screws (A).
Fuel Tank, Radio Plate
1. Place the air filter element (135) onto the air filter base (136).
2. Secure the air filter element (135) onto the base (136) by installing the air filter top
(134) and securing it all together with the 3x8mm flat head self tapping screw (A).
3. Install the air filter neck (137) onto the bottom of the air filter base (136). Secure
the air filter neck (137) to the base using a tie-strap (151).
4. Secure the other end of the air filter neck (137) to the engine using another tie-
strap (151).
Air Filter
1. Secure the engine onto the engine mount (3) using (4) 4-40x3/8" socket head screws
(C) and (4) 3mm lock washers (P). NOTE: Make sure a generous amount of thread
locking compound is applied to the screws before installing them.
2. Secure the engine mount (3) to the chassis (1) using (6) 3x8mm socket head screws (A).
Engine Mount, Clutch
1. Install the flywheel collet (129) onto the engine’s crankshaft.
2. Install the flywheel (130) onto the engine’s crankshaft, making sure the
collet (129) fits properly into the flywheel (130).
3. Install a crankshaft locking tool (not included) into the engine and install
the pilot shaft (133). Note: Make sure you thoroughly tighten the pilot
shaft onto the engine’s crankshaft.
4. Install the two clutch shoes (131) onto the flywheel pins. Note the
direction of the clutch shoes in the drawing. The clutch shoes should
be installed in this direction for optimal performance.
5. Install the clutch spring (132) into the groove of the clutch shoes (131).
6. Install a 5x8 flanged bearing (103) onto the pilot shaft (133).
7. Install the clutch bell (80) onto the pilot shaft (133)making
sure the bearing fully seats into the clutch bell (80).
8. Install the second 5x8mm flanged bearing (103) into
the end of the clutch bell (80). Again, make sure the
bearing is fully seated into the clutch bell (80).
9. Install a 5mm washer (X) onto the end of the
pilot shaft (133). Secure the clutch assembly
with a 4mm e-clip (DD).
