5
❏
1. Install the “AA” batteries in the transmitter.
❏
2. Install and extend the transmitter antenna.
❏
3. Install (4) “AA” batteries into the receiver battery box (refer to
RTR section).
❏
4. Connect the servos and receiver battery to the receiver.
❏
5. Uncoil and extend the receiver antenna.
❏
6. Adjust the servo trims of the transmitter to the neutral position.
❏
7. Switch on the transmitter.
❏
8. Switch on the receiver.
❏
9. Operate the steering and throttle control. Make sure the
steering and throttle servo arms move in proportion to the
movement of the steering wheel and throttle trigger.
❏
10.Switch off the receiver, then the transmitter.
❏
1. Remove the Nitro Evader BX and the parts bag from the box.
❏
2. Locate and remove from the Parts Bag 2: steering servo mounts
(6), one servo arm (8) (determine which servo arm is required for
your radio system), one ball stud (81), one foam washer (67), two 3x8
pan head screws (L) and two 3x8 flat head machine screws (A).
❏
3. Attach the servo mounts (6)
to the servo using the two (2)
3x8mm screws (L) as shown.
❏
4. Install the ball stud (81) into the flat side of the steering servo
arm (8) in the upper hole. With the steering servo centered as
described in “Preparing the Radio System,” install the correct
steering servo arm onto the servo splines as shown above, making
sure that the servo arm is as close to vertical as possible. Note: If
the steering servo is not properly centered, the steering could be
off. Center the servo and then reinstall the servo horn screw,
securing the horn onto the servo.
❏
5. Remove the (3) 3x10mm (I) and (2) 3x15mm screws (H) from
the top of the upper brace (52). Remove (2) 3x8mm flat head
machine screws (A) that hold the upper brace to the main chassis
(1). Remove the upper brace from the main chassis.
❏
6. Install the steering servo into the mounting slot. Line up the
holes in the servo mounts with the two holes in the chassis. Note:
There are two different mounting holes in the servo mounts. Use
the appropriate holes for your servo. Install the two (2) 3x8 flat
head machined screws (A) through the bottom of the chassis into
the servo mounts.
❏
7. Attach the steering link ball cup (5) onto the ball stud (81) on
the servo.Note: Do not reinstall the upper brace (52) back onto the
chassis (1) until later.
STEERING SERVO ASSEMBLY
PREPARING THE RADIO SYSTEM
FINISHING THE NITRO EVADER BX PRE-BUILT VERSION (DTXC0067)
