14
1. Insert the two bellcrank screw posts (99 & 100) into the bottom of
the chassis (1). The long screw post (100) should be installed on the
left side of the Nitro Evader chassis when viewed from the rear. Secure
the bellcrank screw posts (99 & 100) to the chassis (1) with the 4mm
hex nuts (Z).
2. Install ball studs (81) into the right bellcrank (46) in the holes shown.
3. Insert a plastic bushing (48) into each end of the right steering
bellcrank (46). Make sure the bushings are fully seated.
4. Slide the assembled right bellcrank onto the short aluminum
bellcrank screw post (99).
5. Install ball studs (81) into the lower left bellcrank (44) in the holes shown.
6. Insert the threaded aluminum servo saver hub (101) into the bottom
of the lower left steering bellcrank (44). Note: The aluminum servo
saver hub is designed to key into the bottom of the lower left
steering bellcrank. Make sure that the hex in the hub fully seats
in the bellcrank.
7. Install a ball stud (81) into the upper left steering bellcrank (45).
8. Insert a plastic bushing (48) into each end of the threaded post
guide (101). Again, make sure the bushings are fully seated.
9. Slide the servo saver hub (101) and lower left bellcrank assembly
onto the long servo saver shaft (100). Then install the upper left
steering bellcrank (45) onto the lower left steering bellcrank (44).
Note: The upper and lower left steering bellcranks are designed
to key together.
10. Place the servo saver spring (98) on top of the upper left steering
bellcrank (45).
11. Secure the left bellcrank assembly together with the aluminum
servo saver spring adjuster nut (102). Note: The servo saver spring adjuster is machined on one side for the servo
saver spring to fit into. Make sure this side goes down against the servo saver spring. Adjust the servo saver so
the top edge of (102) is even with the top edge of (101).
12. Slide the assembled left bellcrank assembly onto the screw post (100). Attach the left and right bellcranks with the one
piece molded link (43).
Steering Bellcrank Assembly
1. Attach the servo mounting lugs (6) to
the rear of the servo mounts on the servo
using (2) 3x8 self tapping screws (L).
2. Install a ball stud (81) into the steering
servo horn (8). Insert the ball stud into the
hole furthest from the center.
3. Install the steering servo horn onto the
servo. Note: Make sure the transmitter,
steering servo and servo horn are
properly centered before securing the
servo horn to the servo.
4. Secure the servo to the chassis with
(2) 3x8mm flat head screws (A).
Servo
