❏
6. Remove the receiver battery holder from the radio box.
Install (4) “AA” (included) into the battery holder in the
configuration molded into the battery holder.
❏
7. Re-install the receiver battery holder under the radio
plate. Make sure that the receiver switch is in the off
position. Plug the connector on the receiver battery into the
socket on the receiver switch. Tuck the wires between the
servo and receiver battery so they will not get caught on
anything.
❏
8. Remove the transmitter antenna from the holder and
screw it into the hole on top of the transmitter.
❏
9. Slide open the battery door on the bottom of the
transmitter and remove the transmitter battery holder. Place
8 “AA” batteries into the holder in the configuration molded
into the plastic on the battery holder. Re-install the
transmitter battery holder into the transmitter and re-install
the battery door.
❏
10. Turn on the transmitter using the switch on the back
(see the photo with Step 8), The green light on the side of
the transmitter should light up. If there is no light on, turn the
transmitter off and check to ensure that the battery holder is
making contact with the copper contacts on the inside of the
battery compartment. Make sure the batteries are installed
correctly. Turn the transmitter on and check for the green
indicator light. If the green light appears, turn off the
transmitter.
❏
11. Remove the plastic from the outside of the body.
Apply the decals if desired. For decal placement, see the
photos on the box top.
5
