Throttle Linkage Set Up
A) With the radio system still on, set the throttle in the
neutral position.
B) Remove the servo arm from the throttle and replace the
arm so that it is aligned with the centerline of the throttle
servo case.
C) The brake lever should be perpendicular (i.e. straight) to
the centerline of the chassis as shown above.
D) Tighten the 2mm collar on the brake rod so that it is 3/32"
(2mm) away from the brake lever.
E) Push the throttle rod with your finger until the carb closes
as far as possible (the carb will not close completely which
is normal).
F) Tighten the set screw on the outer collar and cut the
throttle rod flush with the outer 2mm collar.
G) Move the throttle spring next to the rod connector.
H) Tighten the inner 2mm collar next to the throttle spring
without compressing the spring.
I) Attach the throttle servo arm with the screw included with
your radio system.
❏
1. Remove the fuel tank by taking out the two screws on
the bottom of the chassis.
❏
2. Remove the fuel line, air cleaner, and tie-strap from the
parts bag.
❏
3. Cut the fuel line in half. Route one of the lines from the
nipple on the top of the muffler to the top of the fuel tank.
Route the other fuel line from the nipple on the carburetor to
the bottom of the fuel tank. Ensure that the fuel line is not
kinked anywhere along the line. You may have to shorten
the line to eliminate kinks.
PREPARE THE ENGINE
12
