Dukane Infinity 43NSLA, Быстрый старт

Страница: 35 / 65

SE
CTION 4
| C
ONTR
OLS
AND
I
NDICA
TORS
Infinity™ Series Servo Ultrasonic Press Systems QUICK START GUIDE
31
3. Lock all the handles tightly by turning them clockwise as shown in Fig. 4-42.
4. If desired, the orientation of the handles can be changed once they are locked. referring to Fig. 4-43, pull the handle
straight out (1), rotate it in either direction (2), then release it (3).
Figure 4-42 Tightening Lock Handles Figure 4-43 Handle Orientation
Aligning the Fixture
The fixture must be properly aligned and leveled to the horn to ensure consistent, evenly distributed welds. To safely align
the fixture under the horn, use the following procedure.
1. Place unwelded parts into the fixture.
2. Ensure the E-STOP is released, then start up the system normally.
3.
Perform the following steps in IQ Explorer 3 software:
a. For Trigger Type, select Force
b.
Press Teach next to Sensing Start Position
4. Hold the two operate switches to lower the horn. Before the horn makes contact with the parts, change the Speed
to Medium, then hold the switches again to lower the horn further.
5. When the horn is close to the parts, approximately 0.025", move the fixture to align the parts to the horn. If necessary,
the press may be moved down to slightly compress the parts to aid in alignment.