Duerkopp Adler 745-34, Инструкция по эксплуатации

Страница: 126 / 156

Correction of the swivelling width
–
Loosen screw 2. (ill. on the top left corner of page 123)
–
Adjust the lower stationary flap clamp 3 in transverse direcction by
turning the toothed wheel 1. (ill. on the top left corner of page 123)
–
Tighten screw 2.
–
Make the fine adjustment with stop screw 4 and counternut 5.
Standard checking
The distance between the stationary flap clamp and the fabric sliding
sheet should amount to approx. 1-3 mm.
Correction of the lowering depth
–
Loosen counternut 9. (ill. on the top left corner of page 122)
–
Turn the stop screw 10. (ill. on the top left corner of page 122)
Hint
The fabric must be easily displaceable.
–
Tighten counternut 9.
–
Align the flap clamp in longitudinal direction parallel to the fabric, if
required.
Adjusting the movable flap clamp
For a uniform and displacement-free clamping the point of the movable
clamp 1 should first strike the stationary clamp 2.
–
Set the clamping power with screw 8 (ill. at the bottom of
page 121).
The stationary clamp must not bend down.
–
Align the movable clamp 1, if required.
–
Align the movable clamp in raised position as to the stationary
clamp.
124
4 5
1 2