4
while closing the gate press P/P button in the position of required slowing down (8a, fig.3).
4
the gate finishes the closing move at the outermost closing position. L1 diode turns off, the end of
programming procedure (8, fig.3).
6.3. Pause time modification
The procedure must be conducted when the gate is closed. Procedure of the pause time modification
set during the programming in the pt. 6.1:
4
press PROG/STOP button and hold it until the L1 diode turns on.
4
press PROG/STOP button again, L1 diode starts blinking and the driver starts remembering pause time.
press PROG/STOP button again when demanded pause time is complete. L1 diode turns off.
Procedure completed
6.4. Wicket time programming
Opening the gate for pedestrians (wicket function) is already programmed in the factory settings for
about 1-1,5 metres. If this opening requires modification, act in the following way using JOLLY input (clamp 10 fig.
2):
4
With the gate, closed, enter the programming mode by holding the PROG./STOP button up to the moment
until a L1 diode turns on.
4
Press PED button, the gate starts opening.
4
Next press PED button at the moment when the gate reaches the demanding position of opening for
pedestrians.
4
The gate stops, next it starts closing. The drives goes out from the programming mode.
9
Programming
8
GATE CLOSED
END OF PROGRAMMING
L1 LED LIGHTS OFF
OK
8a
PRESS P/P
TO SET SLOWDOWN
MOMENT
P/P
slow
7
PRESS P/P
SAVING THE TIME
STARTS CLOSING
P/P
6
GATE OPENED
AUTO-CLOSING TIME
COUNTDOWN
auto-close
6a
PRESS P/P
TO SET SLOWDOWN
MOMENT
P/P
slow
5
AFTER A MOMENT
GATE STARTS TO OPEN
1
PLACE GATE IT THE
MIDDLE
- LOCK THE DRIVE
2
PRESS FOR 5s.
PROG./STOP BUTTON
UNTIL L1 LIGHTS ON
PROG.
/
STOP
5s.
3
PRESS P/P
P/P
4
GATE WILL CLOSE
Fig.3.
Programming in simple mode
(p.1-8 without 6a and 8a) and extended (1-8 with p. 6a, 8a).
Содержание SWIFT6
Страница 2: ......
