C. Operation mode
Description:
After turning on the power supply, the receiver goes automatically into the OPERATION MODE - it is
signalized by glowing of the LED dot on the right side of the display. In this mode, remote controls the receiver’s
outputs. After pressing the programmed remote’s button, the proper output will be turned on according the
preferences made by the user - the LEDs corresponding to the channels show actual outputs state.
Indications of the display:
In the stand-by mode only the dot on the right side of the display glows.
After pressing any button of the programmed remote, the display will show: the number
of remote’s button and the number of the remote in the receiver’s memory.
All this information will be shown in three phases as on the example in the left: P1 - means that
channel number one was activated, the next numbers (0) and (01 ) show the number of the
remote in receiver’s memory - 001.
Remarks !
After turning on the power supply, the receiver goes automatically into the OPERATION MODE.
4
If the receiver is connected to USB interface, the display will show
U
sign (see page 28).
4
8
