D. Simple registering of the remote without using the receiver’s buttons
Rival 434 has a feature allowing a user to add a new remote to the receiver’s memory without using the
receiver’s buttons. This feature is useful only if any registered remote is also available.
The bc option from the receiver’s menu (see page 16) can block this feature for the specific remote. It is also
possible to block this feature for all the remotes (see page 23).
Simple registering procedure.
Remarks !
The possibility of registering a new remote without using the receiver’s buttons will reduce the safety of the
4
system. The remotes with bc a turned off option should be protected against any unauthorised persons.
You can not use a button working in momentary mode for this procedure.
4
Tab. 1
9
C
L
6
6
6
Remarks
You have to be as close as possible to the radio receiver (but no closer than 1m). The receiver must be in the OPERATION
MODE.
Press and hold for 15 seconds button 2 of the remote that is already in the receiver’s memory. The simple registering
blockade for this remote must be turned.
The pause between operations number 3 and 5 must be less than 3 sec.
Press button 2 of a new remote for at least 15 seconds.
The new remote has been registered in the receiver’s memory. The preferences for this remote have been copied from
preferences of the remote used for registering (from operation no 2).
It was not possible to register a new remote. Possible reasons: - too big radio interferences. - The battery of one of the
remotes was too low for such a long transmission.
Operations
Radio range
Button of the already
registered remote
>15 s
<3s
Button of a new remote
>15 s
The remote has been added
Adding has failed
1
2
8
Pos.
4
6
3
5
7
