2 Video matrices
Issue 4
Page 2.1 - 2
Installation
Please read section 1.3 ‘ Safety and Pre-Installation checks’ before proceeding.
For a single level matrix with local control simply connect the video inputs and
outputs as shown on the rear panel (terminating any unused BNC’ s at 75
Ω
),
connect the mains mating IEC connector to a suitable 230v supply (NB Earth
MUST be connected at all times) and the matrix is ready for use.
When a system requires a number of Routemaster matrices to be permanently
married (e.g. video and audio, video and stereo audio, component video and
audio), connect the married cable between the units being operated together with
the 4C014 married cable supplied (if not supplied see ‘ connection for married
operation’ below).
For units with remote control connect the appropriate Routemaster(s) to the
control panel with the control cable(s) supplied.
NB When video and audio Routemaster(s) are permanently married, the video acts
as the master. Control panels should be connected to the video unit. When
matrices are married for component video, ensure that control panel(s) are
connected to the Y/G matrix so that syncs are derived correctly.
Section 4.2 covers the 5S2935 16 button per cross point control panel and
section 4.3 the 5SX4100 XY control panel.