2 Video matrices
Issue 4
Page 2.3 - 2
•
Can be married to other video levels for component (YC, YUV, RGB or RGBS)
operation and to audio units for audio follow video with break-away available
dependant on the type of control panel fitted.
Installation
Please read section 1.3 ‘ Safety and Pre-Installation checks’ before proceeding.
For a single level matrix, connect the video inputs and outputs as shown on the
rear panel (terminating any unused BNC’ s at 75
Ω
) then connect the mains mating
IEC connector to a suitable 230v supply (NB Earth MUST be connected at all
times).
For multiple levels connect the married cables between the units being operated
together with the 4C014 married cable(s) supplied (if not supplied see
‘ connection for married operation’ below). If being married to other component
levels ensure the unit designated Y/G is connected appropriately so that sync is
derived from the correct level. For the 16x8 Routemaster two married cables are
required, one to interconnect the married connectors for outputs 1-4, the other to
interconnect the married connectors for outputs 5-8. For the 16x4 Routemaster
only one married cables is required to interconnect the married connectors for
outputs 1-4.
For units with remote control connect the appropriate Routemaster(s) to the
control panel(s) with the control cable(s) supplied. NB When video and audio
Routemaster(s) are married, the video acts as the master. Remote or local control