DRS WJ-8611, Инструкция по установке, эксплуатации и обслуживанию

Страница: 92 / 301

WJ-8611 DIGITAL VHF/UHF RECEIVER
REMOTE CONTROL 4-7
Table 4-1. Receiver Device Messages (Continued)
Command Response Description
BWS nrf
BWS? BWS nr1
Selects an IF bandwidth by specifying its IF bandwidth slot
number. (See
paragraph 1.5 on Software Version 01.00.07.)
Range: 1 - 17
Where: 1 = 0.00020 9 = 0.01500
2 = 0.00050 10 = 0.02000
3 = 0.00100 11 = 0.03000
4 = 0.00320 12 = 0.03500
5 = 0.00500 13 = 0.05000
6 = 0.00640 14 = 0.06000
7 = 0.00800 15 = 0.10000
8 = 0.01000 16 = 0.15000
17 = 0.20000
Requests the selected IF bandwidth by its slot number.
Reset: BWS
08
Default: BWS 08
BYP nrf Selects the bypass path in the RF preselector to disable the front
end bandpass filtering.
Range: 0,
1
Where: BYP 0 - Bypass off
BYP 1 - Bypass on
BYP? BYP nr1 Requests the current bypass path status.
Reset: BYP
0
Default: BYP 0
CFG? CFG nr1 Requests the status of the receiver's configuration mode. The
data returned consists of one byte identifying whether the
receiver is in the normal or configuration mode.
Where:
CFG 0 = Normal mode
CFG1 = Configuration mode
Reset: CFG0
Default: CFG0
CLM nrf Clears memory channels, lockout channels, or all memory.
Range: 1-3
Where:
1 = Memory channels only
2 = Lockout channels only
3 = Both memory and lockout channels
CLT nrf Sets the COR loss timer. The loss timer specifies the amount of
time, in msec, that a signal must be below the COR threshold
after detection, before the signal loss is reported.
Range:
0 - 2000 msec
CLT? CLT nr1 Requests the current COR loss timer setting.
Reset: CLT
0000
Default: CLT 0000
Courtesy of http://BlackRadios.terryo.org