Drivecon Inc. reserves the right to alter or amend the above information without notice.
:
7.3.1 TRANMITTER
In WORKING mode, the 5 green LEDs should light as described in Starting-up procedure. If
this is so, press the transmitter motion buttons and observe the response of the output relays. If
the response is normal, the problem is not related to the remote control equipment and the
installation must be checked. If any of the relays is not activated, the problem is associated with
the remote control equipment.
LED
COLOR
ON
FLASHING ON
OFF
SIGNAL
Green
-
Receiver doesn’t
receive any RF signal.
Own or more Radio
Systems sharing the
own channel
POWER
Green
Power supply OK
-
Power supply NOTOK
Green
Board OK
Failure in board
HARD
OK
Slow: Failure in board.
Fast: EEPROM error
ID
Green
-
ID Code OK
Not recognised ID
Code
DATA
Green
-
Own or other valid
messages are presents
No correct messages
are being received.
If the problem is associated with the equipment, please send both the transmitter and the
receiver to the Technical Assistance Service, together with a description of the problem and the
status of the LEDs.
Page 17 of 18
LED
MEANS
Green double flashing
Transmitter ready for start-up
Solid green
Transmitter transmitting normally
Red flashing
Battery level low
Red double flashing
Transmitter cannot start up because a manoeuvre
command is present
Solid red
Transmitter failure
7.3.2 RECEIVER
