DRESSTA 32501, Руководство оператора

Страница: 43 / 177

MACHINE TRANSPORT AND STORAGE
SECTION 3
Page 9
DRESSTA TD-15H
MACHINE STORAGE
3.4.2. SERVICING MACHINE DURING STORAGE
ONE-MONTH REPETITIVE SERVICE PERIOD
MACHINES EQUIPPED WITH MAINTENANCE-FREE BATTERIES
Check if batteries are fully charged. Never allow batteries to run down below ¾ full charge.
SIX-MONTH REPETITIVE SERVICE PERIOD
1. Visually inspect the engine and radiator for leakage and other defects. Correct all defects. If
necessary, consult Authorized Distributor of Construction Equipment.
2. Remove all storage seals from the machine. (i.e. crankcase and hydraulic breathers, engine air
intake, fuel tank vent lines, etc.).
3. Install fully charged batteries. Refer to "ELECTRICAL SYSTEM", Section 5.
IMPORTANT: Check that batteries are level in the holder and securely held. The hold-down
fasteners should hold the batteries firmly but not tight enough to warp or damage either the hold-
down bar or batteries.
WARNING! The ends of wires should be so arranged that access to the plugs is
ensured. Lay the cables so that the wires should not rub hold-down bars or its
fasteners. Always connect the negative ground cable last to minimize the chance
of sparks or explosion.
4. Check the coolant level in the radiator and add proper concentrations of antifreeze and coolant
conditioners, if required. Refer to “COOLING SYSTEM”, Section 5.
NOTE: If excessive loss of coolant is detected, the problem should be corrected. Refer to
“COOLING SYSTEM”, Section 5.
5. Perform steps 7 through 22 of "PREPARING FOR STORAGE".
3.4.3. PREPARING FOR OPERATION AFTER STORAGE
1. Visually inspect the machine for external leakage and other defects.
2. Clean the radiator, refer to “COOLING SYSTEM”, Section 5.
3. Thoroughly clean and wash the machine.
4. Correct any defects found. Consult Authorized Distributor of Construction Equipment if
necessary.
5. Remove all storage seals from the machine (i.e. crankcase and hydraulic breathers, engine air
intake, fuel tank vent lines, etc.).
6. Replace the air cleaner filter elements. Refer to “AIR CLEANING SYSTEM”, Section 5.
7. Remove and discard fuel filters and replace with new ones. Refer to “FUEL SYSTEM”,
Section 5.
8. Fill the fuel tank with approved diesel fuel. Refer to “REFILL SPECIFICATIONS AND
CAPACITY CHART”, Section 5.
9. Lubricate all points of the machine as outlined in the “SERVICE GUIDE”, Section 5.
https://www.truck-manuals.net/