DRESSTA 32501, Руководство оператора

Страница: 74 / 177

SECTION 4
OPERATING
Page 28
TD-15H DRESSTA
OPERATING MOUNTED EQUIPMENT
4.17.7. BULLDOZER BLADE POSITIONS
4.17.7.1. TILTING THE BLADE WITH MECHANICAL TILT
1. Raise the blade 400 [mm] above the ground and shut off the engine. Refer to STOPPING THE
ENGINE.
2. Remove the locking pin and adjust the upper strut on the side to be raised. Extend the strut by
the value equal approximately to half of the required blade tilt.
IMPORTANT: Do not expose any portion of the eyebolt threads.
3. Adjust the opposite side to get the desired tilt by shortening the strut by the value equal to
remaining part of the desired tilt. Install the locking pin.
Fig. 4.25. Blade tilt
1. Tilt to the Right 2. Tilt to the Left
NOTE: Do not tilt the blade more than 560 [mm] tip to tip.
4.17.7.2. TILTING THE BLADE WITH HYDRAULIC TILT
1. To obtain a desired tilt of 400 [mm] or less, proceed as follows:
a) Raise the blade about 450 [mm] off the ground.
b) Hold the tilt control lever in the tilt position on the side to which the blade is to be tilted until
the desired tilt is obtained.
2. To obtain a tilt of 400 [mm] to maximum 710 [mm], proceed as follows:
a) hold the tilt control lever in the tilt position until the piston rod in the tilt cylinder is either fully
extended or retracted (depending upon the side to be tilted). Shut off the engine. Refer to
“STOPPING THE ENGINE”.
b) Adjust the mechanical strut as described under “TILTING THE BLADE WITH MECHANICAL
TILT”.
https://www.truck-manuals.net/