Dremel 3D40 FLEX, Оригинальное руководство пользователя

Страница: 551 / 588

MAINTENANCE AND SERVICE
Problem Cause Corrective Action
Extruder head building off center. Dremel 3D40 FLEX has lost track of
the extruder head’s exact location and
is failing to build.
Sending the extruder head to the home
position will recalibrate the Dremel
3D40 FLEX. Cancel your object, clear
build platform, send the extruder head
to the home position, and restart the
object.
PLA is not extruding or sticking to the
build tape properly.
This can be caused by the build
platform not being leveled with the
extruder head.
Leveling the build platform will align
the extruder head and ensure a better
object quality. Cancel your object, clear
build platform, level the build platform,
and restart the object.
Dremel 3D40 FLEX froze before my
object started.
Dremel 3D40 FLEX may have received
conflicting commands.
Turn power switch off, wait 30
seconds, and turn power switch on.
Support material does not break
away during cleaning and results in
decreased quality of the final object.
Orientation of the part is not optimized. Reorient the position of the 3D file in
your file slicing software to minimize
the support material or place the
support material on a non-critical
surface.
Spaghetti mess at end of build. A layer of your object did not stick
properly, model was saved with
minimal surface area contacting the
build platform, or object was built
floating above the build platform with
no support selected.
Use your file slicing software to see
the first layer height and position. Build
with supports when necessary.
Part only built halfway. Filament ran out.
Filament clogged during build.
Replace filament and resume build.
See “No filament coming out”.
No filament coming out. Clogged extruder. Contact customer service.
Extruder will not home. Contact customer service.
Stringy or fraying plastic layers on
steep overhangs.
Object overhangs are too far apart or
too steep (<45 degree angle).
Build with supports.
3D40 FLEX will not find my Wi-Fi
network.
Printer too far from wireless router. Reposition 3D40 FLEX to be closer to
your router.
Connect to network with Ethernet.
3D40 FLEX will not connect to my
network.
Printer too far from wireless router. Reposition 3D40 FLEX to be closer to
your router.
Network password incorrect. Re-enter your password or verify your
password with your network owner.
551