Dremel 3D40 FLEX, Оригинальное руководство пользователя

Страница: 19 / 588

2. After extruder stops moving, open the 3D40 FLEX
Lid for better access to extruder.
3. If existing filament is loaded, cut existing filament
near extruder intake and tap “Next” button on
touchscreen.
4. Remove Spool door by rotating it counter clockwise
and remove existing spool if one is present, see
figure1.
FIG. 1
Open
Close
Filament Filament Guide Tube
Spool Holder
FIG. 2
Guide Tube Filament Filament Guide Extruder intake
5. Thread tip of new filament through guide tube,
place spool on spool holder, replace spool door by
aligning locking tabs and rotating clockwise, see
figure 1.
Tap “Next” on touchscreen.
6. If changing existing filament, 3D40 FLEX will
automatically purge existing filament.
7. When Feed Filament screen appears, tap “Next” on
touchscreen and thread filament coming from guide
tube into extruder intake until extruder feeds
through on its own, see figure 2.
8. Filament will be drawn into the extruder and begin
to exit from the hot extruder tip.
NOTE: Your Dremel 3D40 FLEX was tested by
building objects before leaving the factory. These
test objects may have been made with a different
filament color than you are using. Therefore, a
small amount of filament may be remaining in the
extruder.
9. When new filament appears from extruder tip, tap
“done” on touchscreen to complete filament load
process, return to main menu, and calibrate
extruder. Carefully remove excess filament without
touching hot extruder tip. If necessary, carefully
remove debris from extruder tip with needle nose
pliers.
!
WARNING
USE EXTRA CARE NOT TO
DAMAGE THE EXTRUDER TIP
WHEN CLEARING DEBRIS. DREMEL 3D40 FLEX WILL
NOT WORK PROPERLY WITH A DAMAGED
EXTRUDER TIP AND WILL REQUIRE REPLACEMENT.
10. Close 3D40 FLEX lid and door.
19