7
ENIGMA-X / SPARKLE manual Ver 6 Rev 4 07/2016
Fig 3
Fig 4
Door end of guide rail
High spot of disk bushing
1
2
4
3
6
5
EQ
EQ
glass bracket
disk
measure
3.
Attach the
Upper guide rail (#03)
to the
Stationary glass
(#02)
with the
Glass brackets (#07)
and tighten the bolts into
the pre-drilled holes in the
Upper guide Rail (#03)
. Make sure
both adjustment disks are installed in the same direction with
the high spot towards the door end. (see
*
Note below)
Make sure that the guide rail is attached parallel with the top
edge of the stationary panel glass.
Slide the
Door Stoppers (#01)
onto each end of the
Upper
guide rail (#03)
and secure them temporarily using the
4mm
allen wrench. (#11). Install the panel-end stopper into the
pre-drilled stopper hole in the Upper Guide Rail (Fig 3.3).
Slide the
Guide Rail brackets (#08)
onto each end of the
Upper guide rail (#03)
and temporarily secure them as well.
Next, assemble the
Wall Bracket (#19)
onto the bottom
corner of the
Stationary glass (#02)
as shown in FIG 3.5.
Use the provided gaskets to protect the glass.
See Fig. 3 and Fig. 4 for details
*NOTE:
The outer glass bracket disk has an eccentric bushing
for adjustment. Be sure to install both glass bracket disks with
the high spot of the bushing pointed towards the door end of
the guide rail. See the detail of the disks below as viewed from
inside prior to installing on the glass.
