Installation steps
6
ENIGMA-X / SPARKLE manual Ver 6 Rev 4 07/2016
Fig 1
Fig 2
W
Top
Middle
Bottom
2-3/4
”
minimum
door end
door end
glass bracket
holes
Small Stationary Glass (#23)
Small Stationary Glass (#23)
1.
Measure the distance between the two
finished walls at the top, middle and bottom.
This distance is marked as
“W”
.
Also, check the threshold for level and the
walls for plumb.
See Fig 1 for details
2.
The
Upper Guide rail (#03)
has been pre-cut for the
model width of: 48
”,
60” or 72” (the actual rail is shorter
than the model width by design).
Cut the
Upper Guide rail (#03)
from the door end only,
which is the end that is farther from the
Glass bracket
(#07)
holes. The length to cut off will be “
L” :
Model Width – finished opening W = cut off length L
See Fig 2 for details
*FOR EXAMPLE:
If the model width is 48” and the finished opening is 46”,
then you will need to cut 2” off from the door end of the
rail:
Example: 48” – 46” = 2” cut off
Model Width – finished opening W = cut off length L
*Note that this is only an example and the actual
cut-off length will vary based on the actual finished
opening dimension.
Note:
The minimum threshold requirement for
the ENIGMA-X is
2-3/4” of flat threshold space
.
